54
AVR-3808CI / AVR-3808 / AVC-3808
6. DPMS Updateg
6.1. AboutthedisplayontheFLDisplay
Display State Measure
1
Upper Login failed
Log-in to DPMS has failed.
→
Perform the resetting procedure, then perform the
update procedure over again.
Lower
2
Upper Server is busy
Line, etc., is busy when logging into DPMS.
→
Then perform the update procedure over again.
Lower
3
Upper Connection fail
Not connected to network.
→
Check the network connection.
Lower
4
Upper
Status prior to starting update procedure.
Lower Updating
5
Upper
Currently updating.
The progress of updating is indicated in % at "xx".
Lower Updating xx%
6
Upper Updating failed
Updating has failed.
→
Turn the power off then back on. Updating starts
automatically.
Lower
7
Upper
Please wait・・・
Displayed when updating resumes after it has failed.
Lower Update retry
8
Upper Update retry
Log-in to DPMS after automatic update recovery has
failed.
→
Perform the resetting procedure, then perform the
update procedure over again.
Lower Login failed
9
Upper Update retry
Line, etc., is busy when logging into DPMS after
automatic update recovery, etc.
→
Turn the power off then back on. Updating starts
automatically.
Lower Server is busy
10
Upper Update retry
Connection to network could not be performed when
connecting to network after automatic update recovery.
→
Check the network connection.
Lower Connection fail
6. DPMSアップデートg
6.1. FLDisplay 表示に関して
表示内容 状態 対処
1
上段 Loginfailed
DPMS への Login に失敗した。 →
初期化の操作を行い、再度、Update の操作をおこ
なってください。
下段
2
上段 Serverisbusy
DPMS への Login の際に回線等が混み合っている。 → 再度、Update の操作をおこなってください。
下段
3
上段 Connectionfail
Network に接続していない。 → Network の接続を確認してください。
下段
4
上段
Update 開始前の状態。
下段 Updating
5
上段
Update 実行中。
xx に Update の進行状況が % で表示されます。
下段 Updatingxx%
6
上段 Updatingfailed
Update に失敗したとき。 →
電源を入れなおしてください。自動的に Update が
開始されます。
下段
7
上段 Pleasewait…
Update 失敗後に、再度 Update が開始される場合に
表示されます。
下段 Updateretry
8
上段 Updateretry
Update の自動リカバリ実行後に DPMS への Login に
失敗した。
→
初期化の操作をおこない、再度、Update の操作をお
こなってください。
下段 Loginfailed
9
上段 Updateretry
Update の自動リカバリ実行後に DPMS への Login 等
の際に回線等が混み合っている。
→
電源を入れなおしてください。再度、自動的に
Update が開始されます。
下段 Serverisbusy
10
上段 Updateretry
Update の自動リカバリ実行後に Network へ接続した
際に Network への接続がおこなえなかった。
→ Network の接続を確認してください。
下段 Connectionfail