Chapter 2 Getting Started the BHT and System Mode
11
! Host PC
Models: PC/AT, PS/2
Optional application programs and OSs
OS MS-DOS Win3.1 Win95 Win98 WinNT3.5/4.0
Win2000
Professional
Win XP
BHT-BASIC
Compiler
BHT-BASIC3.0
(MS-DOS–based)
BHT-BASIC3.0
(Windows3.1-
based)
BHT-BASIC3.5/3.6
Ir-Transfer Utility C
MS-DOS–based –
Win95-/NT-based
Ir-Transfer Utility E
– –
Win95-/NT-
based
Win95-/NT-
based*
Win95-/NT-
based
Win95-/NT-based*
Transfer Utility
MS-DOS-based
Windows3.1-
based
Win95-/NT-based
*This application does not activate any built-in IrDA interface port.
! CU-8001/8002/8021 and RS-232C/USB Interface Cable (option)
The CU-8001/8002/8021 is an IrDA-compliant communication unit that is required when your host PC is
not equipped with an IrDA interface port. The CU-8001/8002/8021 exchanges data and programs with
the BHT optically, and with the host PC via the RS-232C interface cable (CU-8001/8002) or USB
interface cable (CU-8021).
You may directly connect two BHTs with each other by using a commercially available metal cable
having 3-pole mini stereo plugs (as a direct-connect interface cable). You also connect the BHT directly
with the host PC or with the modem by using the direct-connect interface cable compatible with the
target equipment. (NOTE: The direct-connect interface port of the BHT is not designed to stand frequent
connecting/disconnecting. You are, therefore, recommended to use the CU-8001/8002/8021 where you
expect to do a lot of connecting and disconnecting of the BHT to/from a host PC.)
! BHT-BASIC Compiler (option)
This Compiler compiles a source program written in BHT-BASIC by an editor of the host PC running the
MS-DOS, into the object program (user program) which can be used in the BHT. The compiled and
linked program file is named "XXX.PD3."(XXX: File name you can set arbitrarily under the MS-DOS
rules) You should download it to the BHT by using Ir-Transfer Utility C/Ir-Transfer Utility E/Transfer
Utility.
! Ir-Transfer Utility C (option)
Running on the host PC, this utility transfers files between the BHT and the host PC. It uses the BHT-Ir
protocol as a file transfer control procedure. (For the details about the BHT-Ir protocol, refer to Chapter 3,
Section 3.4.2.)
To transfer files under any of the following conditions, use Ir-Transfer Utility C:
- At transmission speeds of 115200 or 57600 bps (This may be impossible depending upon the host PC
type.)
- When the BHT is placed on the CU-8001/8002/8021
- When transferring via the direct-connect interface of the BHT
To Next Page
Loading...
