Denso BHT-8000 - Adjusting the LCD Contrast & Beeper Volume and Switching the Beeper & Vibrator

Chapter 2 Getting Started the BHT and System Mode
25
2.3.3 Adjusting the LCD Contrast & Beeper Volume and
Switching the Beeper & Vibrator
While holding down the M1 or M4 key (right-hand trigger switch), press the PW key, and any of the
following screens will appear on the LCD. This screen will disappear if you press the ENT key or no keys
for five seconds.
When the beeper is selected
(default)
When the vibrator is selected
When both the beeper and
vibrator are selected
(The current selection is highlighted.)
Adjusting the LCD contrast
You can adjust the LCD brightness to eight contrast levels.
(1) Use the F5 and F6 keys to select the LCD CONTRAST line.
(2) To decrease the contrast, press the F7 key; to increase it, press the F8 key.