66
Setting the communications protocol type
Selecting the "4:PROTOCOL TYPE" on the SET COMMUNICATION
menu calls up the screen shown at left.
Highlighted is the current setting.
[1] BHT Protocol: Selects the BHT-protocol for downloading o
uploading files in System Mode or for the
execution of XFILE statement in BHT-BASIC.
This protocol should be selected for the use
of Transfer Utility.
[2] BHT-Ir Protocol: Selects the BHT-Ir protocol for downloading
or uploading files in System Mode or for the
execution of XFILE statement in BHT-BASIC.
This protocol should be selected for the use
of Ir-Transfer Utility C or Ir-Transfer Utility E.
Select a desired item by using the numerical keys or F5 and F6 keys,
and then press the ENT key.
To return to the SET COMMUNICATION menu, press the C key.
Selecting the "2:BHT-Ir Protocol" on the PROTOCOL TYPE screen
calls up the screen shown at left.
Enter the ID number of the BHT by using the numerical keys, and
then press the ENT key. If you do not need to modify the current
setting, press the ENT key only.
An ID number should be five-digit decimal character string. Th
entry range is from 00001 to 65535. If the entry value is less than
five digits, the ENT key will be deactivated.
If you make a wrong entry, press the BS key to delete it and then
enter the correct data.
To return to the SET COMMUNICATION menu, press the C key.
To Next Page
Loading...
