DETEWE opencom 100 - Output volume Tab; Input volume Tab

13
Installation Ports
Ports
Besides the power socket, the Open-
Com 100 has the following ports
(please see also Positions of the Ports
starting on page 15):
OpenCom 100
■ Four analogue a/b ports,
realised as pressure clamps (a/b
1 to a/b 4)
■ Two actor ports for connection
to a door opener and entrance
intercom system, realised as
pressure clamps (Actor1 for acti-
vating a door opener and Actor2
for activating an entrance inter-
com)
■ One sensor port for connection
to the bell of an entrance inter-
com system, realised as pressure
clamps (Sensor)
■ One PCM port for the connection
of two systems; realised as RJ-45
socket (PCM)
OpenCom 105
■ One S
0
port for connection to an
external S
0
bus (usually the
NTBA), realised as RJ-45 socket
(S
0
1)
■ Two switchable S
0
ports (S
0
2
and S
0
3), which can be con-
nected to either an internal or
an external S
0
bus. The internal
port is realised as pressure
clamps, the external port as an
RJ-45 socket.
■ One S
0
port for an internal S
0
bus, realised as pressure clamps
■ Four U
pn
ports, realised as pres-
sure clamps (U
pn
1to U
pn
2)
■ One LAN port (10BaseT), real-
ised as an RJ-45 socket
■ One COM port for connection to
a PC for configuration or transfer
of call data, realised as an RJ-45
socket
OpenCom 110
■ Two S
0
ports for connection to
an external S
0
bus (usually the
NTBA), realised as RJ-45 sockets
(S
0
1 and S
0
2)
■ Two switchable S
0
ports (S
0
2
and S
0
3), which can be con-
nected to either an internal or
an external S
0
bus. The internal
port is realised as a pressure
clamp, the external one as an RJ-
45 socket.