DETEWE opencom 100 - Configuration Guide

55
Configuration Guide
Configuration Guide
The Configuration Guide contains a
series of flowcharts which will help
you to plan the configuration of the
OpenCom 100 and guide you
through the necessary settings step
by step, focusing on the network set-
tings. The individual charts are sum-
marised below:
Note: Please note that the settings
for mail and for ISP and RAS access
are only possible if you have released
the OpenCom 100 IP package . The
package is released on the Web con-
sole Configurator in the SYS Configu-
ration: Licences menu.
■ Overview: This chart gives you
an overview of the initial config-
uration of the OpenCom 100.
■ Configuring the PBX Ports: This
chart shows you the necessary
steps for configuring the ports
and the terminals.
■ Configuring the Easy Access:
This chart guides you through
the TCP/IP settings for the Open-
Com 100.
■ Configuring the ISP Settings:
These instructions will help you
make the necessary settings for
configuring the Internet access.
■ Configuring the RAS Settings:
This chart guides you through
the configuration of the RAS set-
tings.
■ Configuring the LAN-to-LAN
Settings: This chart guides you
through the configuration of the
LAN-to-LAN settings.
■ Configuring the E-Mail
Function:
This diagram tells you how to
create the requirements needed
for configuring the OpenCom
100 e-mail access function.
■ Configuring the E-Mail Access:
This overview provides instruc-
tions on configuring the Open-
Com 100 e-mail access server.