68
LAN Frequently Asked Questions
Another manufacturer’s cordless
DECT telephone is not functioning.
In the Configurator, make sure GAP has
been set for this telephone (PBX Config-
uration: Ports: DECT-PP menu).
LAN
It is not possible to establish a net-
work connection with the OpenCom
100.
Check whether the LEDs for the hub and
the PC’s network card are indicating a
connection.
Remove the labelling strip and check the
LEDs for the LAN functions of the Open-
Com 100. The green LAN LED at the top
indicates whether the network cable has
been properly connected. The red LAN
LED at the bottom indicates whether
there is any network traffic on the line.
To check whether there is a network con-
nection with your OpenCom 100, enter
the “ping IP address” command in “Run”
in the Windows Start menu (e.g. ping
192.168.99.254).
How can I determine the IP address
of the OpenCom 100?
To find out what the IP address is, enter
the code number
*182 at one
of the connected system telephones.
The code-number procedure
*183 also displays the network
mask.
The network connection is function-
ing, but nothing is displayed in the
browser.
Enter the complete IP address of the
OpenCom 100 along with the protocol
identifier, for example, http://
192.168.99.254/.
To Next Page
Loading...
