18 Pictures for illustrating purposes only
ELECTROVAP MC2 STEAM BATH
Models & Optional features
This model includes a Steam Bath remote control, a 12V supply transformer
together with a 3 dry contact control board. The 12V supply transformer
powers the light (12V bulb or skylike ceiling) and the remote control.
The Remote Control (IP54) makes it possible to communicate with the
steam generator and to display information. As well, the steam production,
the hammam light, the pre-set temperature together with the perfume
diffusion (if this option has been activated in the menu) can be programmed on a weekly basis. For
further information, please revert to the Remote Control manual.
This option is an Emergency Button to be installed inside the Hammam room. A push on
this button stops immediately the steam generator, starts the ventilation device or the
exhaust air system and shuts a relay that can be linked to a warning light, a bell alarm or
to some other warning device. Please revert to the Optional feature documentation for
further information.
Option - Emergency button
The model includes a push button, a 3 dry contact control board and a two-colour
green/red lamp. When there is no Remote Control, a mere push on this button
powers the steam generator for about 30 minutes (adjustable time). A red ligth is
shown when the steam bath steams up and it turns green when it is ready for use.
Further details can be found in our time bath documentation.
Time bath
This optional perfume dispensor consists in a dosing pump, a 7L perfume tank and a
coil assy to be connected to the steam hose. This option is powered by the steam
generator through terminals 3 & 4. The injection time and period can be selected either
in the steam bath « changing parameters » menu or through the Steam Bath Remote
Control (option 1 or 2 compulsory). Please consult the Perfume Dispensor manual for
further information.
Perfume dispensor
Disinfection dispensor
This optional disinfection dispensor consists in a dosing pump, a 7L disinfectant tank and a check
valve assy to be connected onto the water piping . This option is powered by the steam generator
through terminals 3 & 4 or trough the 3 or 8 dry contact board (if option 1 or 2 is installed). The
disinfection time and period can be selected in the steam bath « changing parameters » menu.
Please consult the Perfume Dispensor manual for further information.
3 contact remote control model
To Next Page
Loading...