7 Pictures for illustrating purposes only
What is in the box :
1. One temperature controlled ElectroVap MC2 steam bath fitted with disposable or cleanable
cylinder(s) (at purchaser’s request) and one user’s manual.
2. 3 wire temperature sensor with 10 m. long connecting cable.
3. One 500mm long flexible hose with 3/4” thread (with washers) for tap water connection.
4. Ø 25 mm drain hose :
ELMC 1 cylinder : 1 m. long
ELMC 2 cylinders : 2 hoses of 1 m. long and 1.2 m. long respectively
ELMC 3 cylinders : 3 hoses of 1 m. long, 1.2 m. long and 1.8 m. long
4. Hose clamps :
ELMC 1 cylinder : 3 clamps (2 pieces for the steam hose & 1 piece for the drain hose)
ELMC 2 cylinders : 6 clamps (4 pieces for the steam hoses & 2 pieces for the drain hoses)
ELMC 3 cylinders : 9 clamps (6 pieces for the steam hoses & 3 pieces for the drain hoses)
ELECTROVAP MC2 STEAM BATH
Delivery contents
1
4 3
5
Any loss or damage during delivery should be reported to carrier by registered letter
within 3 working days and be advised to devatec or to authorized dealer.
It is recommended that the ElectroVap Steam MC2 Bath be kept in its transit
packaging for as long as possible prior to maintenance. If the generator is to be put
into storage prior to installation, it must be stored under cover and protected from
physical damage, dust, frost, rain and humidity. More than 6 months storage is not
recommended.
2
To Next Page
Loading...