4 Pictures for illustrating purposes only
ELECTROVAP MC2 STEAM BATH
Safety information
IMPORTANT
This section should be read carefully to ensure safe and correct installation of your steam bath generator.
GENERAL
This manual contains all details necessary for the planning and installation of the ElectroVap MC2 Steam
Bath. In addition commissioning and maintenance details are included.
The manual is intended for use by engineers and properly trained technical personnel. Maintenance, servicing
or repair work must only be carried out by suitable skilled and qualified personnel, the customer must be re-
sponsible for ensuring their suitability.
Any risks or hazards, especially when working from ladders or towers should be identified by a skilled and
Health and Safety representative and effective control measure put in place.
No liability will attach to the Distributor if any damage, injury or accident is attributable to inattentive, inappro-
priate, negligent or incorrect operation of the machinery whether or not caused deliberately. Always isolate all
electrical and water supplies before commencing any maintenance.
Every effort has been made to ensure details contained in this manual are correct, however, in view of the
wide range of conditions experienced in air handling systems, the information provided should only be used as
a guide. Please contact your Agent if any doubt.
Correct use
The ElectroVap Steam MC2 Bath is ONLY intended for use of steam inside hammam rooms and controlled by
temperature within specific working conditions . ANY OTHER APPLICATION IS NOT CONSIDERED USE
FOR THE INTENDED PURPOSE. THE MANUFACTURER CANNOT BE MADE LIABLE FOR ANY DAMAGE
OR HARM RESULTING FROM INCORRECT USE.
Water
The ElectroVap MC2 Steam Bath is designed to be used with mains, demineralized R/O with a minimum con-
ductivity of 30 µs or softened water. On no account attempt to introduce any other fluid or chemical into the
system. Water supply should not exceed 6.0 bar and installation should comply with local regulations. In case
the water pressure exceeds 6.0 bar, a water regulator valve must be used.
Electricity
All work concerned with electrical installation MUST only be performed by skilled and qualified technical per-
sonnel (eg electrician or technicians with appropriate training). The customer MUST be responsible for ensur-
ing their suitability.
It is the duty of the installer to ensure that suitable sized cables and MCB protection is provided. Please ob-
serve the local regulations concerning the provision of electrical installations.
Warranty
A one year warranty term—cost and labor—is applicable to the parts of the ElectroVap MC2 Steam Bath to
the exception of the consumable parts (valves, cylinders or parts of cylinders) provided our recommendations
of use & maintenance have been adhered to. Failure to specify and fit original parts and accessories will inva-
lidate our warranty.
NOTE
The manufacturer’s policy is one of continuous research and development. He therefore reserves the right to
amend without notice the specifications given in this document.
The photographs are for illustrating purposes only.
To Next Page
Loading...