10. Service Mode Field Service Ver. 1.0 Apr. 2005
102
ineo 161
ineo 210
Adjustment / Setting
G. ADF F/W VER.
H. MAIN RAM SIZE
I. PCL RAM SIZE
J. SERIAL NO.
K. CUSTOMER ID
10.3.5 FUNCTION
• FUNCTION allows the various service functions (paper feed test, image printing) to be
checked and adjustments to be made.
A. PAPER FEED TEST
B. PROCESS CHECK
Purpose/Use To display the ADF firmware version information.
✽ Only when the optional Duplexing Document Feeder (DF-605) is mounted
Purpose/Use To display the main memory size.
Purpose/Use To display the PCL memory size.
✽ Only when the optional Printer Controller (Pi2001e) is mounted
Purpose/Use To display the serial number of the copier.
Purpose/Use To display the customer ID of the copier.
Purpose/Use • To check for correct paper passage of the paper take-up and transport system by let-
ting the copier consecutively take up and feed paper without involving actual printing
action.
• Here are the details of operation involved in the paper passage motion.
• The Scanner does not make any scan motion.
• Paper is fed until the corresponding paper source runs out of paper.
• This test cannot be run with the Manual Bypass or Multiple Bypass (option).
• No counters are activated.
✽ When a paper misfeed occurs
Setting/
Procedure
<Step>
1. Select the paper source.
TRAY1 TRAY2
2. Press the Start key to start the paper feed test.
✽ Press the Stop key to stop the paper feed test.
Purpose/Use HV output (for factory setting only) *Should not be used
To Next Page
Loading...
