DEVO-7 Page 89 of 170
menu. Press UP or DN to get twinkling “STMOD”, and then press ENT to enter stick
mode selection. Press R or L to choose stick model you desired, and then Press ENT
to confirm.
Press EXT to exit after finished.
1.4 Calibration
Press “ENT” key in main interface then it will appears twinkling main menu. Press UP
or DN to get twinkling “CALIB”, and then press ENT to enter calibration menu.you can
start calibration after press ENT key.
Press ENT to start stick calibration, it appears below interface.
Stick Calibration: Clockwise or counter clockwise mechanically move the right stick
and left sticks from their minimum levels to their maximum levels several times, and
then return the sticks to the neutral positions, respectively.
If shows below interface after press EXT, it means calibration is finished.
To Next Page
Loading...
