11 • Next sensor session | Dexcom ONE+ User Guide
52
Remove while using sensor
To remove old sensors from the Bluetooth connections list while you are wearing one, follow the above steps and keep these
tips in mind:
l
All Dexcom sensors are listed as not connected, even the current one. The current sensor’s status changes to connected
during the few seconds every 5 minutes when it’s sending your sensor reading to your phone. If you watch the list for up to
5 minutes, you’ll see which sensor is the current one.
l
Don’t worry if you remove the current sensor. Within 5 minutes, the sensor will send your next sensor reading to your
phone and the sensor will reappear in the Bluetooth connections list. (If you use an iPhone, it will prompt you to re-pair the
sensor — no pairing code needed. Android phones do this automatically.)
To Next Page
Loading...
