11.3. PROGRAMMING CODES [ 7 3 ]
This option is used for programming the access codes to the
scale’s different programming options. They are 4-digit
codes. The structure is the following:
A Super user code allows access to all programming options.
In addition there are 4 codes with restricted access to certain
programming options. These codes are:
11.3.1. Master Password [ 7 3 1 ]
This key permits access to all programming.
To program this code, do as follows:
1. Press MENU 2 seconds.
2. Press 7 3 1
3. The scale will display the message: “Enter new Super
user code”. Type in the 4-digit code.
4. Press ∗
∗∗
∗
5. Press MENU 2 seconds to quit the programming menu.
11.3.2. Programmation Password [ 7 3 2 ]
If this code is programmed, it will have to be entered in order
to gain access to programming: 1- Articles, 3-Section
configuration, 4- Texts, 6- Formats..
To program this code, do as follows:
1. Press MENU 2 seconds.
2. Press 7 3 2
3. The scale will display the message: “Enter new article
code”. Type in the 4-digit code.
4. The machine will ask you to repeat the key.
5. Machine will display OK.
6. Press MENU 2 seconds to quit the programming menu.
11.3.3. Vendors Passwords [ 7 3 3 ]
If this code is programmed, it will have to be entered in order
to gain access to programming: 2- Employees Code.
To program this code, do as follows:
1. Press MENU 2 seconds.
2. Press 7 3 3
3. The scale will display the message: “Enter new
employee code”. Type in the 4-digit code.
4. Repeat the code and will display OK.
Press MENU 2 seconds to quit the programming menu.
To Next Page
Loading...
Need help?
General
