5.CONFIGURATION [
3 ]
5.1. MAIN CONFIGURATION
These parameters allows to program the operative setup of the
section where the scale is installed.
The access to the main programming menu is gained by pressing
the key MENU for 2 seconds.
After gaining access to the programming mode, select the option
3 Section Configuration and press
∗
∗∗
∗
.
Change from one option to another by using F2 to go down the
menu and F1 to go up.
An option can also be selected by entering its code using the
number keys.
To exit Configuration programming, press MENU
When the lower level of the programming menu is shown, it is
possible to print a list of the parameters by pressing the key
PRINT.
5.1.1.PC Configuration [ 3 1 ]
This programming allows to define all the parameters related to
the communication with PC.
To enter in this menu press MENU for 2 seconds and then 3 1.
Change from one option to another by using F2 to go down the
menu and F1 to go up.
The access to the submenus it is possible by pressing the key
∗
∗∗
∗
or by entering directly the code of the each submenu.
To exit Configuration programming, press MENU
To Next Page
Loading...
Need help?
General
