4.VENDORS [ 2 ]
The maximum number of vendors available on each scale will
depends on the model.
• For models: W-010, W-015, M-510 & M-515 Max.: 5
vendors.( V5 )
• For models: W-020, W-025, M-520 & M-525 Max.: 10
vendors.( V10 )
The keys corresponding to the vendors will be labelled with the
key V followed by a number which identificates the vendor
number (V1, V2, etc...)
The vendors must have previously been registered in the
corresponding memory in order for the operations carried out by
the same to be stored. If this is not the case it is not possible for
the operations to be stored and the associated keys V1, V2,...
Vxx are out of order.
Remember that this type of programming can only be done on a
MASTER scale.
4.1. REGISTERING VENDORS [ 2 1 ]
To register the memory of a new vendor.
1. Make sure the scale is set up as master and access the
programming menu MENU
2. Type in the access code to programming of vendors 2 1
3. Press the key you wish to assign to the new vendor, for
example V4.
The symbol L indicates that the selected memory is FREE. If this
message does not display, it means that the chosen memory is
being used by another sales assistant. See section 4.2
REMOVING SALES ASSISTANTS if you wish to free this
memory.
4. Enter a five digit code for the new sales assistant (for example
2 7 0 5 4).
4. Press X to confirm and go on to enter the operator’s name.
5. Enter the name* (maximum 26 characters) of the new sales
assistant: the current position of the cursor will display in the
bottom left hand corner.
7. Press ∗
∗∗
∗ to confirm: the next sales assistant’s screen will show
(in this case, that of V5).
8. Go to point 3 if you wish to register a new sales assistant, or
press the MENU key to quit the programming menu.
To Next Page
Loading...
Need help?
General
