2.2. STARTING UP
Each of the following steps must be completed to start operating
the scales:
STEP 1: Install the scales as described in sect
1.4.INSTALLATION OF SCALE and switch on as
described in sect. 2.1.SWITCHING ON.
STEP 2: Programme the weighing scale communications, i.e.,
set up the scales as MASTER or SLAVE and assign
the corresponding address (See sect.7.4.1.1 Set up
as MASTER-SLAVE)
STEP 3: If the scales are being used for the first time, or you
wish to programme them again, the memory should
be deleted. (See sect. 7.3.4. INITIALIZATION OF
SCALE)
STEP 4: Assign each of the sales assistants who is to use the
scales one of the 20 available memories, i.e. register
the employees (See sect. 4 REGISTERING
VENDORS)
STEP 5: Programme the articles. (See sect. 3.1ARTICLES )
STEP 6: If the scales are for operation in a EU country, check
that the current EURO PHASE is set up correctly.
(See sect. 11.1.7 PROGRAMMING EURO)
STEP 7: Select the receipt format or programme a new one
(See sect 9.2 RECEIPT).
STEP 8: Programme printing parameters (See sect. 11.4.
PRINTING PARAMETERS ).
STEP 9: Set up the label formats (See sect. 9.11 PROGRAM
LABEL FORMAT)
STEP 10: Start to work with the scales, referring to the next
section 2.3 HOW TO OPERATE THE SCALES.
To Next Page
Loading...
Need help?
General
