4.Memorise the operation for the corresponding sales assistant by
pressing one of the, V1, V2..., Vxx keys. These memory keys
must have been registered beforehand. (See sect. 4.1.
REGISTERING VENDORS ).
5. Remove the article and then start again with the next one.
If you want to to check the total amount of sale before
totalizing, hold pressed the vendor’s key of the corresponding
sale for 2 seconds. The display will show for a few seconds the
number of sales the vendors has until that moment.
2.3.3. Non-weight operations (adding, subtraction
and multiplication)
The scales are able to function with articles that are not sold by
weight (price/kg), but which have a price per article, such as a
bottle of milk.
The scales must be programmed to enable adding, subtraction
and/or multiplication operations. (See sect. 5.1.2.5
MULTIPLICATION , 5.1.2.7 SUBTRACTION and 5.1.2.6
ADDITION).
The method of operation is as follows:
1. Press + or - depending on whether you wish to add or
subtract.
2. Enter the price/unit of the product, as explained in section
2.3.2 NORMAL WEIGHT. In the event of an error, press
C to set the price to zero.
3. Memorise the operation for the corresponding sales
assistant by pressing one of the V1,..., Vxx keys. These
memory keys must have been registered beforehand.
(See sect. 4.1. REGISTERING VENDORS)
If more than one unit is to be added or subtracted before being
memorised, press X and enter the number of products.
If the MULTIPLICATION parameter is set to “2”, then the units
must be indicated in all unit sales. Therefore, if an attempt is
made to memorise a unit sale that is not multiplication, the
scales will beep and the following message will appear on the
display:
“Enter units”.
2.3.4.Manual zero
The scales are equipped with a manual reset to zero mechanism.
If, for any reason the value of the weight is not zero, but it is within
a certain range, press keys SHIFT and 0, to reset the weight to
zero.
To Next Page
Loading...
Need help?
General
