7.3.2.Send end of day without totals deletion
[ 5 3 2 ]
This operation allows you to forward the data stored in the scale
to the computer for their subsequent processing by a suitable
program like DIBAL RMS.
The totals accumulated will NOT be cleared to zero.
1. Enter by pressing MENU (2 seconds) 5
3 2.
2. To do so, press the
∗
∗∗
∗
key 4 times.
3. Then, press MENU (2 seconds) to quit the programming
menu.
7.3.3.Request start of day [ 5 3 3 ]
This operation allows you to send the data on receipt text, the
registering of sales assistants, section and department names,
etc. from the computer to the scale by means of a suitable
program like DIBAL RMS.
1. Enter by pressing MENU (2 seconds) 5
3 3.
2. Press the
∗
∗∗
∗
key.
3. Then, press MENU (2 seconds) to quit the programming
menu.
7.3.4.Initialization of scale [ 5 3 4 ]
With this operation it is possible to delete all data from the scales
except data on logos, fonts, ingredients and all customer
information (customer number, pending payments, etc.). The
PLUs and sales assistants’ memories will be deleted.
1. Enter by pressing MENU (2 seconds) 5
3 4.
2. Press the
∗
∗∗
∗
key 7 times.
3. Then, press MENU (2 seconds) to quit the programming
menu.
If the scales are a MASTER, after start-up all PLUs must be
re-programmed, either manually or by downloading them from
the PC. The same process must also be followed for the sales
assistants and other set-up values. If the scales are a SLAVE,
when the delete option has been effected, the scales will
request that new articles should be sent from the corresponding
MASTER.
7.3.5.BACKUP (LBS) [ 5 3 5 ]
This operation allows you to forward the data stored in the scale
to the computer for a backup.or to resend the data from the
computer to de scale.
Press MENU (2 seconds) 5 3 5
Press
∗
∗∗
∗
.
In the computer select the option
Receive o Send
To Next Page
Loading...
Need help?
General
