If the user sets a value other than ‘1’ or ‘0’, reopening is enabled
for a specific length of time. Once this time has passed the receipt
can no longer be reopened.
Use the table below to configure the reopening time, depending
on the ‘X’ parameter.
Parameter
Reopening time
2 1 min.
3 1 min. 30 sec.
4 2 min.
5 2 min 30 sec.
6 3 min.
7 3 min. 30sec.
8 4 min.
9 Without reopening time limit
5.1.5.5. Two Pay Mode
[ 3 5 5 ]
Dibal’s 500 Range scale allows two forms of payment. (see
Section.2.3.21 Two Pay Mode).
‘NO’ – One form of payment
‘YES’ – Two forms of payment
5.1.5.6. Barcodes per Section in Voucher
[ 3 5
6 ]
The Dibal 500 Range scales permits a voucher obtaine specific
information of the sales by section.
‘0’ – Barcodes per section are not printed.
‘1’ – In one receipt the information about all the sections is
printed. In the Voucher is obatined the barcode for each
section of which have been made sales on the receipt.
‘2’ – One receipt and a voucher are printed by section, which
prints the barcode associated with the corresponding section.
‘3’ – A receipt is printed by section (without voucher), which
prints the barcode associated with the corresponding section.
The code of each section is programmable (See sec 6.3
SECTIONS) being by default if there is not asigned another one
2KKNNNNEEEEE.
To Next Page
Loading...
Need help?
General
