Digi IX10 - Page 11

IX10 User Guide
11
Virtual Router Redundancy Protocol (VRRP) 283
VRRP+ 283
Configure VRRP 283
Configure VRRP+ 287
Example: VRRP/VRRP+ configuration 295
Configure device one (master device) 295
Configure device two (backup device) 300
Show VRRP status and statistics 305
Virtual Private Networks (VPN)
IPsec 309
IPsec data protection 309
IPsec mode 309
IPsec modes 309
Internet Key Exchange (IKE) settings 309
Authentication 310
Configure an IPsec tunnel 310
Configure IPsec failover 338
Configure SureLink active recovery for IPsec 341
Show IPsec status and statistics 357
Debug an IPsec configuration 358
Configure a Simple Certificate Enrollment Protocol client 360
Example: SCEP client configuration with Fortinet SCEP server 367
Show SCEP client status and information 372
OpenVPN 375
Configure an OpenVPN server 376
Configure an OpenVPN Authentication Group and User 385
Configure an OpenVPN client by using an .ovpn file 390
Configure an OpenVPN client without using an .ovpn file 393
Configure SureLink active recovery for OpenVPN 398
Show OpenVPN server status and statistics 415
Show OpenVPN client status and statistics 416
Generic Routing Encapsulation (GRE) 418
Configuring a GREtunnel 418
Show GRE tunnels 424
Example: GRE tunnel over an IPSec tunnel 425
Dynamic Multipoint VPN (DMVPN) 440
Configure a DMVPN spoke 441
L2TP 448
Configure a PPP-over-L2TP tunnel 448
L2TP with IPsec 457
Show L2TP tunnel status 458
L2TPv3 Ethernet 459
Configure an L2TPv3 tunnel 460
Show L2TPV3 tunnel status 464
NEMO 465
Configure a NEMO tunnel 466
Show NEMO status 471
Services
Allow remote access for web administration and SSH 474
Configure the web administration service 478