Digi IX10

Routing Virtual Router Redundancy Protocol (VRRP)
IX10 User Guide
302
Task 3: Configure the IP address for the VRRP interface, ETH, on device two
1. Click Network > Interfaces > ETH > IPv4
2. For Address, type 192.168.3.2/24.
3. For Default gateway, type the IP address of the VRRP interface on the master device,
configured above in Task 3, step 2 (192.168.3.1).
Task 4: Configure SureLink for ETH on device two
1. Click Network > Interfaces > ETH > IPv4 > SureLink.
2. Click Enable.
3. For Interval, type 15s.
4. Click to expand Test targets > Test target.
5. For Test Type, select Ping test.
6. For Ping host, type https://remotemanager.digi.com.
Task 5: Configure the DHCP server for ETH on device two
1. Click to expand Network > Interfaces > ETH > IPv4 > DHCP Server
2. For Lease range start, type 200.
3. For Lease range end, type 250.
4. Click Advanced settings.
5. For Gateway, select Custom.