Interfaces Wireless Wide Area Networks (WWANs)
IX10 User Guide
84
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config network interface my_wwan surelink actions 0)>
override_interval int
(config network interface my_wwan surelink actions 0)>
n
reset_modem.
If reset_modem is selected, complete the following:
l
Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config network interface my_wwan surelink actions 0)> max_
attempts int
(config network interface my_wwan surelink actions 0)>
The default is 3.
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config network interface my_wwan surelink actions 0)>
override_interval int
(config network interface my_wwan surelink actions 0)>
n
switch_sim: Switches to an alternate SIM.
If switch_sim is selected, complete the following:
l
Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
(config network interface my_wwan surelink actions 0)> max_
attempts int
(config network interface my_wwan surelink actions 0)>
The default is 3.
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config network interface my_wwan surelink actions 0)>
override_interval int
(config network interface my_wwan surelink actions 0)>
n
modem_power_cycle.
If modem_power_cycle is selected, complete the following:
l
Set the number of attempts for this recovery action to perform, before moving
to the next recovery action:
To Next Page
Loading...
Need help?
General
