Digi IX14 User Manual

Interfaces Wireless Wide Area Networks (WWANs)
IX14 User Guide
107
3. Click Network > Interfaces.
4. Create the WWAN or select an existing WWAN:
n
To create a new WWAN, for Add interface, type a name for the WWAN and click .
n
To edit an existing WWAN, click to expand the WWAN.
New WWANs are enabled by default. To disable, click Enable.
5. For Interface type, select Modem.
6. The WWANis enabled by default. Click Enable to disable, or to enable if it has been disabled.
7. Interface type defaults to Modem.
8. For Zone, select External.
9. For Device, select the cellular modem.
10. For Match SIMby, select a SIM matching criteria to determine when this WWAN should be
used:
n
If SIMslot is selected, for Match SIMslot, select which SIM slot must be in active for
this WWAN to be used.
n
If Carrier is selected, for Match SIMcarrier, select which cellular carrier must be in
active for this WWAN to be used.
n
If PLMN identifier is selected, for Match PLMN identifier, type the PLMN id that must
be in active for this WWAN to be used.
n
If IMSI is selected, for Match IMSI, type the International Mobile Subscriber Identity
(IMSI) that must be in active for this WWAN to be used.
n
If ICCID is selected, for Match ICCID, type the unique SIMcard ICCIDthat must be in
active for this WWAN to be used.
11. Type the PIN for the SIM. Leave blank if no PIN is required.

Digi IX14 Specifications

General

Brand	Digi
Model	IX14
Category	Network Router
Language	English