Interfaces Show Surelink status and statistics
IX14 User Guide
149
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show Surelink status and statistics
You can show Surelink status for all interfaces, or for an individual interface. You can also show
Surelink status for ipsec tunnels and OpenVPN clients.
Surelink status is only available from the Admin CLI.
Command line
Show Surelink status for all interfaces
To show the Surelink status all interfaces, use the show surelink interface all command:
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLIprompt, type :
> show surelink interface all
Interface Test Proto Last Response Status
--------- ----------------------------- ----- ------------- -------
LAN Interface is up IPv4 32 seconds Passing
LAN Interface's DNS servers (DNS) IPv4 28 seconds Passing
LAN Interface is up IPv4 21 seconds Passing
LAN Interface's DNS servers (DNS) IPv4 20 seconds Passing
modem Interface is up IPv4 115 seconds Passing
modem Interface's DNS servers (DNS) IPv4 114 seconds Passing
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show Surelink status for a specific interface
To show the Surelink status a specific interface, use the show surelink interface name name
command:
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show surelink interface name name command to show the Surelink status of a specific
interface, for example:
To Next Page
Loading...
Need help?
General
