Digi IX14

Command line interface Command line reference
IX14 User Guide
801
Parameters
name: Name of the capture filter to use.
analyzer save
Saves the current captured traffic to a file.
Syntax
analyzer save <name> <filename>
Parameters
name: Name of the capture filter to use.
filename: The filename to save captured traffic to. The file will be saved to the device's
/etc/config/analyzer directory.
analyzer start
Start a capture session of packets on this devices interfaces.
Syntax
analyzer start <name>
Parameters
name: Name of the capture filter to use.
analyzer stop
Stops the traffic capture session.
Syntax
analyzer stop <name>
Parameters
name: Name of the capture filter to use.
clear dhcp-lease ip-address
Clear the DHCP lease for the specified IP address.
Syntax
clear dhcp-lease ip-address ADDRESS
Parameters
address: An IPv4 or IPv6 address
clear dhcp-lease mac
Clear the DHCP lease for the specified MAC address.