System administration Configure the speed of your Ethernet port
IX14 User Guide
313
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add the VLAN:
(config)> add network vlan name
(config)>
4. Set the device to be used by the VLAN:
a. View a list of available devices:
(config network vlan vlan1)> device ?
Device: The Ethernet device to use for this virtual LAN
Format:
/network/device/lan
/network/device/loopback
/network/vlan/vlan1
Current value:
(config network vlan vlan1)>
b. Add the device:
(config network vlan vlan1)> device /network/device/lan
(config network vlan vlan1)>
5. Set the VLANID:
(config network vlan vlan1)> id value
where value is an integer between 1 and 4095.
6. Save the configuration and apply the change:
(config network vlan vlan1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the speed of your Ethernet port
You can configure the speed of your IX14 device's Ethernet port.
WebUI
To Next Page
Loading...
Need help?
General
