Digi IX14

Interfaces Wireless Wide Area Networks (WWANs)
IX14 User Guide
114
c. Configure when the WWAN's DNS servers will be used:
(config network interface my_wwan)> ipv4 dns value
(config network interface my_wwan)>
Where value is one of:
n
always: DNS will always be used for this WWAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
n
never: Never use DNS servers for this WWAN.
n
primary: Only use the DNS servers provided for this WWAN when the WWAN is the
primary route.
The default setting is primary.
15. Optional IPv6 configuration items:
a. IPv6 support is enabled by default. To disable:
(config network interface my_wwan)> ipv4 enable false
(config network interface my_wwan)>
b. Set the MTU:
(config network interface my_wwan)> ipv4 mtu num
(config network interface my_wwan)>
c. Configure when the WWAN's DNS servers will be used:
(config network interface my_wwan)> ipv4 dns value
(config network interface my_wwan)>
Where value is one of:
n
always: DNS will always be used for this WWAN; when multiple interfaces have the
same DNS server, the interface with the lowest metric will be used for DNS
requests.
n
never: Never use DNS servers for this WWAN.
n
primary: Only use the DNS servers provided for this WWAN when the WWAN is the
primary route.
The default setting is primary.
d. See Configure SureLink active recovery to detect modem failures for information about
configuring active recovery.
Show WWAN status and statistics
WebUI
1. Log into the IX14 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.