Services Network Time Protocol
IX14 User Guide
416
Where value is the timezone using the format specified with the following command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This is used to
adjust the time for log
messages. It also affects actions that occur at a specific time of day.
Format:
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
...
(config)>
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show status and statistics of the NTP server
You can display status and statistics for active NTP servers
WebUI
1. Log into the IX14 WebUI as a user with Admin access.
2. On the main menu, click Status.
3. Under Services, click NTP.
The NTP server status page is displayed.
Command line
Show NTP information
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show ntp command at the system prompt:
> show ntp
NTP Status Status
-----------------
To Next Page
Loading...
Need help?
General
