Services Network Time Protocol
IX14 User Guide
415
Additional Configuration
-------------------------------------------
defaultip Default IP
defaultlinklocal Default Link-local IP
lan LAN
loopback Loopback
modem Modem
config)>
Repeat this step to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add service ntp acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to list additional firewall zones.
Note By default, the access control list for the NTP service is empty, which means that all
downstream hosts connected to the IX14 device can use the NTP service.
7. (Optional) Set the timezone for the location of your IX14 device. The default is UTC.
(config)> system time timezone value
(config)>
To Next Page
Loading...
Need help?
General
