Central management Configure multiple devices using profiles
IX14 User Guide
513
3. View the central management configuration:
(config)> show cloud
drm
cellular_keep_alive 290s
drm_url my.devicecloud.com
keep_alive 60s
keep_alive_misses 3
retry_interval 30s
enable true
(config)>
1. Type cancel to exit configuration mode:
(config)> cancel
>
2. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
To view the status of your device's connection to Remote Manager, use the show cloudcommand at
the command line:
Command line
> show cloud
Device Cloud Status
-------------------
Status : Connected
Server : my.devicecloud.com
Device ID : 00000000-00000000-0040FFFF-FF0F4594
>
The Device ID is the unique identifier for the device, as used by the Remote Manager.
Configure multiple devices using profiles
Digi recommends you take advantage of Digi Remote Manager profiles to manage multiple IX14
routers. Typically, if you want to provision multiple IX14 routers:
1. Using the IX14 local WebUI, configure one IX14 router to use as the model configuration for all
subsequent IX14s you need to manage.
2. Register the configured IX14 device in your Digi Remote Manager account.
3. In Digi Remote Manager, create a profile based on the configured IX14.
4. Apply the profile to the IX14 devices you need to configure.
Digi Remote Manager provides multiple methods for applying profiles to registered devices. You can
also include site-specific settings with a profile to override settings on a device-by-device basis.
To Next Page
Loading...
Need help?
General
