Digi IX14 - Configure SSH Access

Services Configure SSHaccess
IX14 User Guide
331
Configure SSHaccess
The IX14's default configuration has SSHaccess enabled, and allows SSHaccess to the device from
authorized users within the Internal firewall zone. If this configuration is sufficient for your needs, no
further configuration is required. See Allow remote access for web administration and SSH for
information about configuring the SSHservice to allow access from remote devices.
Required configuration items
n
Enable SSHaccess.
n
Configure access control for the SSHservice.
Additional configuration items
n
Port to use for communications with the SSHservice.
n
Multicast DNS (mDNS) support.
n
A private key to use for communications with the SSHservice.
n
Create custom SSHconfiguration settings.
See Set the idle timeout for IX14 users for information about setting the inactivity timeout for the SSH
service.
Enable or disable the SSHservice
The SSH service is enabled by default. To disable the service, or enable it if it has been disabled:
WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.