Services Location information
IX14 User Guide
375
Allowed values are:
l
al: Reports altitude and vertical velocity.
l
cp: Compact position: reports time, latitude, and longitude.
l
id: Reports the vehicle ID.
l
ln: Long navigation: reports the latitude, longitude, and altitude, the horizontal and
vertical speed, and heading.
l
pv: Position/velocity: reports the latitude, longitude, and heading.
To remove a message type:
a. Use the show command to determine the index number of the message type to be
deleted:
(config service location forward 0)> show filter_taip
0 al
1 cp
2 id
3 ln
4 pv
(config service location forward 0)>
b. Use the index number to delete the message type. For example, to delete the id
(index number 2) message type:
(config service location forward 0)> del filter_taip 2
(config service location forward 0)>
To add a message type:
a. Change to the filter_taip node:
(config service location forward 0)> filter_taip
(config service location forward 0 filter_taip)>
b. Use the add command to add the message type. For example, to add the id
message type:
(config service location forward 0 filter_taip)> add id end
(config service location forward 0 filter_taip)>
13. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
14. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure geofencing
Geofencing is a mechanism to create a virtual perimeter that allows you configure your IX14 device to
perform actions when entering or exiting the perimeter. For example, you can configure a device to
To Next Page
Loading...
Need help?
General
