Hardware setup Connect the WAN/ETH1 port
IX14 User Guide
32
Connect the WAN/ETH1 port
Use an Ethernet cable to connect the IX14 to your local laptop or PC or to your local network (LAN).
n
If you connect directly to your PC, the factory default IP address is 192.168.2.1
n
If you connect to a LAN that has a DHCP server, reboot the device after you connect and wait
for the DHCP server to assign an IP address to the device.
Connect the serial port
Use an RS-232 serial cable to establish a serial connection from your IX14 to your local laptop or PC.
Use a terminal emulator program to establish the serial connection. The serial port must be
configured to match the configuration of the serial port to which you are connecting. The default
serial port configuration for the IX14 device is:
n
Baud rate: 115200
n
Data bits: 8
n
Parity: None
n
Stop bits: 1
n
Flow control: None
See Serial port.
Power on the IX14
Note The IX14 does not include a power supply or antennas. See IX14 accessory kits for information
on IX14 power supplies and antennas.
1. Power on the IX14 by connecting a DC power source. If you are using a non-Digi power supply,
see IX14 power supply requirements.
2. Power LED is sold blue as the device prepares to boot up.
3. Power LED flashes blue as the device boots up.
4. When the Power LED stops flashing blue and returns to solid blue, the IX14 is ready.
QR code definition
A QRcode is printed on the label attached to the device and on the loose label included in the box
with the device components. The QRcode contains information about the device.
To Next Page
Loading...
Need help?
General
