Digi IX14

Routing IP routing
IX14 User Guide
709
(config network route static 0)> gateway IPv4_address
(config network route static 0)>
8. (Optional) Set the metric for the route. When multiple routes are available to reach the same
destination, the route with the lowest metric is used.
(config network route static 0)> metric value
(config network route static 0)>
where value is an interger between 0 and 65535. The default is 0.
9. (Optional) Set the Maximum Transmission Units (MTU) of network packets using this route:
(config network route static 0)> mtu integer
(config network route static 0)>
10. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete a static route
WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.