Routing IP routing
IX14 User Guide
708
3. Add a new static route:
(config)> add network route static end
(config network route static 0)>
New static route instances are enabled by default. To disable:
(config network route static 0)> enable false
(config network route static 0)>
4. (Optional) set a label that will be used to identify this route. For example:
(config network route static 0)> label "route to accounting network"
(config network route static 0)>
5. Set the IP address or network of the destination of this route. For example:
(config network route static 0)> destination ip_address[/netmask]
(config network route static 0)>
For example, to route traffic to the 192.168.47.0 network that uses a subnet mask of
255.255.255.0:
(config network route static 0)> dst 192.168.47.0/24
(config network route static 0)>
The any keyword can also be used to route packets to any destination with this static route.
6. Set the interface on the IX14 device that will be used with this static route:
a. Use the ? to determine available interfaces:
(config network route static 0)> interface ?
Interface: The network interface to use to reach the destination.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan
/network/interface/loopback
/network/interface/modem
Current value:
(config network route static 0)> interface
b. Set the interface. For example:
(config network route static 0)> interface /network/interface/LAN
(config network route static 0)>
7. (Optional) Set the IPv4 address of the gateway used to reach the destination. Set to blank if
the destination can be accessed without a gateway.
To Next Page
Loading...
Need help?
General
