Digi IX14

Firewall Port forwarding rules
IX14 User Guide
252
Additional Configuration
-------------------------------------------------------------------
-----------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config firewall dnat 0 acl)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete a port forwarding rule
To delete a port forwarding rule:
WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.