Digi IX14

Routing Virtual Router Redundancy Protocol (VRRP)
IX14 User Guide
743
For example, to set interface_down_time to ten minutes, enter either
10m or 600s:
(config network interface LAN ipv4 surelink target 0)>
interface_down_time 600s
(config network interface LAN ipv4 surelink target 0)>
The default is 60 seconds.
l
(Optional) Set the amount of time to wait for an initial connection to the
interface before this test is considered to have failed:
(config network interface LAN ipv4 surelink target 0)>
interface_timeout value
(config network interface LAN ipv4 surelink target 0)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set interface_timeout to ten minutes, enter either 10m or
600s:
(config network interface LAN ipv4 surelink target 0)>
interface_timeout 600s
(config network interface LAN ipv4 surelink target 0)>
The default is 60 seconds.
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example: VRRP/VRRP+ configuration
This example configuration creates a VRRP pool containing two IX14 devices: