EasyManuals Logo

Digi IX14 User Manual

Digi IX14
828 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
Interfaces Wireless Wide Area Networks (WWANs)
IX14 User Guide
113
If enabled:
a. Set the number of times that the device should attempt to connect to the active SIM
before failing over to the next available SIM:
(config network interface my_wwan)> modem sim_failover_retries num
(config network interface my_wwan)>
The default setting is 5.
b. Configure how SIM failover will function if automatic SIM switching is unavailable:
(config network interface my_wwan)> modem sim_failover_alt value
(config network interface my_wwan)>
where value is one of:
n
none: The device will perform no alternative action if automatic SIM switching is
unavailable.
n
reset: The device will reset the modem if automatic SIM switching is unavailable.
n
reboot: The device will reboot if automatic SIM switching is unavailable.
12. The IX14 device uses a preconfigured list of Access Point Names (APNs) when attempting to
connect to a cellular carrier for the first time. After the device has successfully connected, it
will remember the correct APN. As a result, it is generally not necessary to configure APNs. See
Configure cellular modem APNs for further information and instructions for setting an APN.
13. (Optional) To configure the IP address of a custom gateway or a custom netmask:
a. Enable the custom gateway:
(config network interface my_wwan)> modem custom_gw enable true
(config network interface my_wwan)>
b. Set the IP address and netmask of the custom gateway:
(config network interface my_wwan)> modem custom_gw gateway ip_
address/netmask
(config network interface my_wwan)> modem custom_gw
To override only the gateway netmask, but not the gateway IP address, use all zeros for
the IP address. For example, 0.0.0.0./32 will use the network-provided gateway, but with a
/32 netmask.
14. Optional IPv4 configuration items:
a. IPv4 support is enabled by default. To disable:
(config network interface my_wwan)> ipv4 enable false
(config network interface my_wwan)>
b. Set the MTU:
(config network interface my_wwan)> ipv4 mtu num
(config network interface my_wwan)>

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi IX14 and is the answer not in the manual?

Digi IX14 Specifications

General IconGeneral
BrandDigi
ModelIX14
CategoryNetwork Router
LanguageEnglish

Related product manuals