Interfaces Local Area Networks (LANs)
IX14 User Guide
128
1. Log into the IX14 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Command line
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network command at the Admin CLI prompt:
> show network
Interface Proto Status Address
---------------- ----- ------- -------------------------------
defaultip IPv4 up 192.168.210.1/24
defaultlinklocal IPv4 up 169.254.100.100/16
LAN IPv4 up 192.168.2.1/24
LAN IPv6 up fd00:2704::1/48
loopback IPv4 up 127.0.0.1/8
modem IPv4 up 10.200.1.101/30
modem IPv6 down
>
3. Additional information can be displayed by using the show network verbose command:
> show network verbose
Interface Proto Status Type Zone Device Metric
Weight
---------------- ----- ------- ------ -------- -------- ------ --
----
defaultip IPv4 up static setup LAN 10 10
defaultlinklocal IPv4 up static setup LAN 0 10
LAN IPv4 up static internal LAN 5 10
LAN IPv6 up static internal LAN 5 10
loopback IPv4 up static loopback loopback 0 10
modem IPv4 up modem external wwan1 3 10
modem IPv6 down modem external wwan1 3 10
>
4. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific LAN. For example, to display information about LAN, enter show
network interface LAN:
> show network interface LAN
lan1 Interface Status
---------------------
To Next Page
Loading...
Need help?
General
