User authentication LDAP
IX14 User Guide
221
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > LDAP > Servers.
4. Add LDAP servers:
a. For Add server, click .
b. For Hostname, type the hostname or IP address of the LDAP server.
c. (Optional) Change the default Port setting to the appropriate port. Normally this should
be left at the default setting of port 389 for non-TLS and 636 for TLS.
d. (Optional) Click again to add additional LDAP servers.
5. (Optional) Enable Authoritative to prevent other authentication methods from being used if
LDAP authentication fails. Other authentication methods will only be used if the LDAP server is
unavailable.
To Next Page
Loading...
Need help?
General
