Digi IX14

User authentication Example user configuration
IX14 User Guide
236
WebUI
1. Configure a user on the RADIUSserver:
a. On the ubuntu machine hosting the FreeRadius server, open the /etc/freeradius/3.0/users
file:
$ sudo gedit /etc/freeradius/3.0/users
b. Add a RADIUSuser to the users file:
admin1 Cleartext-Password := "password1"
Unix-FTP-Group-Names := "admin"
In this example:
n
The user's username is admin1.
n
The user's password is password1.
n
The authentication group on the IX14 device, admin, is identified in the Unix-FTP-
Group-Names parameter.
c. Save and close the users file.
2. Configure a user on the TACACS+ server:
a. On the ubuntu machine hosting the TACACS+ server, open the /etc/tacacs+/tac_plus.conf
file:
$ sudo gedit /etc/tacacs+/tac_plus.conf
b. Add a TACACS+ user to the tac_plus.conf file:
user = admin1 {
name ="Admin1 for TX64"
pap = cleartext password1
service = system {
groupname = admin
}
}
}
In this example:
n
The user's username is admin1.
n
The user's password is password1.
n
The authentication group on the IX14 device, admin, is identified in the
groupname parameter.
c. Save and close the tac_plus.conf file.
3. Log into the IX14 WebUI as a user with full Admin access rights.
4. On the menu, click System. Under Configuration, click Device Configuration.