Digi IX14

User authentication Example user configuration
IX14 User Guide
238
d. Assign the user to the admin group:
i. Click Groups.
ii. For Add Group, click .
iii. For Group, select the admin group.
a. Verify that the admin group has full administrator rights:
i. Click Authentication > Groups.
ii. Click admin.
iii. Verify that the admin group has Admin access enabled. If not, click Admin access to
enable.
iv. Verify that Access level is set to Full access. If not, select Full access.
7. Click Apply to save the configuration and apply the change.
Command line
1. Configure a user on the RADIUSserver:
a. On the ubuntu machine hosting the FreeRadius server, open the /etc/freeradius/3.0/users
file:
$ sudo gedit /etc/freeradius/3.0/users
b. Add a RADIUSuser to the users file:
admin1 Cleartext-Password := "password1"
Unix-FTP-Group-Names := "admin"
In this example:
n
The user's username is admin1.
n
The user's password is password1.
n
The authentication group on the IX14 device, admin, is identified in the Unix-FTP-
Group-Names parameter.
c. Save and close the users file.