Digi IX14 User Manual

System administration Locate the device by using the Find Me feature
IX14 User Guide
298
4. To deactivate the Find Me feature, click System and click Find Me again.
A notification message appears, noting that theLED is no longer flashing on the device. Click
the x in the message to close it.
Command line
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To activate the Find Me feature, at the prompt, type the following at the command prompt:
> system find-me on
>
3. To deactivate the Find Me feature, type the following at the command prompt:
> system find-me off
>
4. To determine the status of the Find Me feature, type the following at the command prompt:
> system find-me status
off
>

Digi IX14 Specifications

General

Brand	Digi
Model	IX14
Category	Network Router
Language	English