System administration Configure the speed of your Ethernet port
IX14 User Guide
315
l
10—Sets the speed to 10 Mbps.
l
100—Sets the speed to 100 Mbps.
l
1000—Sets the speed to 1 Gbps. Available only for devices with Gigabit Ethernet
ports.
auto—Configures the device to automatically determine the best speed for the
Ethernet port.
The default is auto.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
To Next Page
Loading...
