Services Configure the web administration service
IX14 User Guide
323
3. Enable or disable the web administration service:
n
To enable the service:
(config)> service web_admin enable true
(config)>
n
To disable the sevice:
(config)> service web_admin enable false
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the service
WebUI
1. Log into the IX14 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Web administration.
4. (Optional) For Port, enter the port number for the service. Normally this should not be
changed.
5. Click Access control list to configure access control:
To Next Page
Loading...
Need help?
General
