Digi IX14 User Manual

Configuration and management Change the default password for the admin user
IX14 User Guide
35
3. Click Authentication > Users > admin.
4. Enter a new password for the admin user. The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a new password for the admin user. The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.

Digi IX14 Specifications

General

Brand	Digi
Model	IX14
Category	Network Router
Language	English