Digi IX14

Containers Configure a container
IX14 User Guide
436
5. By default, the container will use the device's system libraries. To disable:
(config system container name)> dal false
(config system container name)>
6. If the device will use virtual networking:
a. Enable virtual networking:
(config system container name)> network true
(config system container name)>
b. Set the network bridge device that will be used to provide network access:
i. Use the ? to determine the available bridges:
(config system container name)> bridge ?
Network Bridge Device: Containers require a bridge to access the
network. Choose
which bridge to connect the container to.
Format:
hotspot_bridge
lan1
Current value:
(config system container name)>
ii. Set the bridge:
(config system container name)> bridge lan1
(config system container name)>
c. (Optional) Set the IP address and netmask for the container:
(config system container name)> address IP_address/netmask
(config system container name)>
d. (Optional) Set the IP address of the network gateway:
(config system container name)> gateway IP_address
(config system container name)>
7. (Optional) Assign serial ports that the container will have access to:
a. Determine available serial ports:
(config system container name)> ... serial
Serial
Additional Configuration
---------------------------------------------------------------------
----------
port1 Port 1