Containers Schedule a script to run in the container
IX14 User Guide
441
5. (Optional) For Label, type container_script.
6. For Run mode, select Interval.
7. For Interval, type 10s.
8. For Commands, type the following:
lxc container_name /bin/ping -c 1 IP_address
For example:
lxc test_lxc /bin/ping -c 1 192.168.1.146
9. Click to disable Sandbox. Sandbox restrictions are not necessary when a container is used.
10. Click Apply to save the configuration and apply the change.
Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a script:
(config)> add system schedule script end
(config system schedule script 0)>
4. Provide a label for the script, for example:
(config system schedule script 0)> label test_lxc
(config system schedule script 0)>
To Next Page
Loading...
Need help?
General
