Applications Digidevice module
IX14 User Guide
477
i. From the command line, at the Admin CLI prompt, type:
> reboot
n
To run the application from the shell prompt:
i. Log into the IX14 command line as a user with shell access.
Depending on your device configuration, you may be presented with an Access
selection menu. Type shell to access the device shell.
ii. Type the following at the shell prompt:
# python /etc/config/scripts/showsystem.py &
#
iii. Exit the shell:
# exit
4. In Remote Manager, click Documentation > API Explorer.
5. Select the devices to use as the SCI targest:
a. Click SCI Targets.
b. Click Add Targets.
c. Enter or select the device ID of one of the devices.
d. Click Add.
e. Enter or select the device ID of the second device and click Add.
f. Click OK.
6. Click Examples > SCI > Data Service > Send Request.
Code similar to the following will be displayed in the HTTP message body text box:
<sci_request version="1.0">
<data_service>
<targets>
<device id="00000000-00000000-0000FFFF-A83CF6A3"/>
<device id="00000000-00000000-0000FFFF-485740BC"/>
</targets>
<requests>
<device_request target_name="myTarget">
my payload string
</device_request>
</requests>
</data_service>
</sci_request>
7. For the device_request element, replace the value of target_name with showSystem. This
matches the target parameter of the device_request.register function in the showsystem.py
application.
<device_request target_name="showSystem">
8. Click Send.
To Next Page
Loading...
Need help?
General
